新闻中心

  • 新闻中心
您现在的位置:主页 > 新闻中心 >

新闻中心

济南灯箱制作安装准备工作

页面更新时间:2015-09-11 11:26 来源:未知 作者:admin 点击:
灯箱在安装前,需要做的准备工作虽然不多,但是却是必须要做的,而且要做好。
 
Before installing the light box, the need to do preparatory work although not much, but it is necessary to do, and to do a good job.
 
一、对于户外立柱式广告灯箱,安装前的准备工作有:
 
One, for outdoor column type advertisement light box, the preparation work before installation:
 
1、需要砌一水泥方墩做安装广告灯箱的准备。
 
1, need to build a cement square pier to do the installation of advertising light box.
 
虽然说广告灯箱的的重量不轻,但为了防止恶劣天气对广告灯箱的影响,还是先砌一水泥方墩为好。水泥方墩要求砌在地面以下位置,方墩大小由广告灯箱的重量和大小而定。
 
Although it is said that the weight is not light, but in order to prevent the impact of bad weather on the advertising light box, or to build a cement square pier is good. The concrete pier is required to be built in the following position, and the size of the square pier is determined by the weight and size of the advertising light box.
 
2、准备一些优质膨胀螺丝。
 
2, prepare some high quality expansion screw.
 
膨胀螺丝用途是将灯箱底座与其下面的水泥方墩固定。
 
The purpose of the expansion screw is to fix the light box base and the concrete pier below.
 
二、对于放在室内的广告灯箱,安装前的准备工作有:
 
Two, for the indoor advertising light box, the preparation of the preparatory work before:
 
1、若是落地式的,可用膨胀螺丝固定即可。
 
1, if the landing type, can be used to expand the expansion screw.
 
2、若是悬挂式的,就要准备好挂件和支架与膨胀螺丝,将灯箱装在房顶上或者墙壁上。
 
2, if the suspension type, it is to be ready to hang and support and expansion screws, the light box installed on the roof or wall.