新闻中心

  • 新闻中心
您现在的位置:主页 > 新闻中心 >

新闻中心

济南广告大字的安装方法

页面更新时间:2015-10-09 11:34 来源:未知 作者:admin 点击:
一、先将单独的字或偏旁的吸塑成品侧边的螺丝拧下,将济南广告大字分为底板和面板两个部分。
 
One, the individual character or radical plastic finished side of the screw, Jinan advertising characters is divided into two parts, the bottom plate and the panel.
 
二、将面板底面避开LED位置钻孔用螺丝固定再安装壁面上,按设计之板安装好,并将每个字的线头固定好。
 
Second, the bottom panel of the surface to avoid led drilling hole position is fixed by the screw to install wall on, installed according to the design of plate and fixed thread on each word.
 
三、在整排济南广告大字 http://www.kangmingda.com/ 的上方或下方排一红一绿的两条主线(2.5的铜芯电线),然后将每个独立的吸塑字或吸塑笔画的线头,按红接红,绿接绿进行并联连接,然后将总线的红绿线对应接入变压转换器。
 
, above or below the whole row of Jinan advertising characters in row one red and one green are the two main lines (2.5 of copper wire), and then the thread on each independent plastic or plastic strokes, by red connected with the red, green pick green connected in parallel, then bus of the red and green lines corresponding to access the voltage converter.
 
四、再将变压转换器的(AC)区域的L、N接入220V电源(2.5的铜芯电线),如安装位置较低,最好接上地线。
 
Four, and then the (AC) region of the L, N access to the 220V power supply (2.5 of copper core wires), such as the installation position is low, the best grounding wire.
 
五、线全部接上,通电后如LED灯不亮,则将LED的主线的红绿位置对换即可。
 
The five line, all connected to electricity, such as LED does not light, LED will be the main line of the red position can be exchanged.
 
六、最后将面板合上拧紧螺丝。路易盖登教你吸塑的一切东西
 
Six. Finally, the panel will be tightened. Louis Gaiden teaches you everything.
 
济南广告大字注意事项:
 
Ji'nan advertising characters note:
 
1、切勿将每个字的线头都直接接到220V电源上,否则LED灯全部报废。
 
1, not every word ends directly to the 220V power supply, otherwise LED lamps are discarded.
 
2、安装前可先用一个字按正确的方法试验一下,再全部安装。
 
2, before the installation can be used a word according to the correct method test, and then all the installation.
 
3、请用防水胶布包好接头,变压转换器应置于防雨区域及通风散热良好。
 
3, please use waterproof tape wrapped joints, transformer should be placed in the rain area and good ventilation and heat dissipation.