新闻中心

  • 新闻中心
您现在的位置:主页 > 新闻中心 >

新闻中心

济南灯箱制作需要完美的工艺与包装

页面更新时间:2015-05-21 11:07 来源:未知 作者:admin 点击:

1、剪边

1, cut edge

电镀结束后,还要将半成品上的余量切掉。把济南灯箱制作半成品放在剪扳机的合适位置,在上面盖一张纸板后再剪切,以免把表面的电镀划伤。

After plating, will cut off the excess of semi-finished products. The Ji'nan light box production of semi-finished products on the appropriate position of the trigger, the above cover a cardboard after shear, lest the surface of the plating scratches.

2、选择装饰板

2, choose decorative plate

后面的装饰板,是放置、安装标牌不可缺少的组成部分。它能使标牌更加完美。

The rear decorative plate is the indispensable part of the placement and installation of the signs. It can make the sign more perfect.

3、粘板

3, sticky plate

在选好的装饰板上,量出并标记好要粘贴的位置。

In the selected trim panel, the amount of the location and mark the location of the paste.

在装饰板上粘两条双面胶带,在四个角和中间位置挤些玻璃胶,撕掉双面胶带上的保护纸,把不锈钢板粘在装饰板上,用力压紧,平放5分钟以上。

In the decorative board stick two strips of double-sided adhesive tape, in the four corners and the middle position of the squeeze some glass glue, double-sided adhesive tape protective paper tear, the stainless steel plate sticking decorative board, hard pressed, flat for more than 5 minutes.

4、保管

4, custody

把已完成的作品,装入包装袋,妥然保管好。

Put the finished work into the package, and keep it safe..