新闻中心

  • 新闻中心
您现在的位置:主页 > 新闻中心 >

新闻中心

趣味DIY,济南冲孔字制作方法

页面更新时间:2015-06-02 11:07 来源:未知 作者:admin 点击:

济南冲孔字制作需要工具:

Ji'nan punching word production need tools:

30W或40W电烙铁,焊锡,电钻,胶枪,螺丝刀等

30W or 40W electric iron, solder, electric drill, glue gun, screwdriver, etc.

济南冲孔字制作需要材料:

Ji'nan punching word production need materials:

成型铁皮字,玻璃胶,电阻,电线,LED招牌专用电源。

Forming metal word, glass glue, resistance, wire, LED signature special power source.

济南冲孔字 http://www.kangmingda.com/ 制作步骤:

Ji'nan punching word production steps:

1.钻孔:把外购的成型铁皮字固定到合适的位置,用电钻钻孔:5MM或8毫米,间距根据外招牌制安装的高度和制作成本而定的,一般LED中心间距为:10--30毫米,间距越小,效果越好,成本越高。

Drilling. The purchased metal forming words fixed to the appropriate location, with an electric drill drilling: 5mm or 8 mm, spacing depending on the signboard outside system installation height and production cost, general led center to center spacing: 10-30 mm, space is small, the better, the higher the cost.

2,插灯:把钻好的孔清理干净,逐一放灯。

2, plug in: the hole to clean the hole clean, one by one lamp.

3.连线:先串联后并联到电源,这一步骤比较难,不用担心, LED灯串,每串有预留的线头,一般 红色的接到电源的正极,黑色的线头接到LED专用电源的负极。

3 line: series parallel to the power supply, this step is more difficult, don't worry, LED light string, each string is reserved for the thread, the received power of positive red and black thread received the cathode of the LED special power supply.

4.测试老化:把所有的LED连好之后,检查处理不亮的,然后进行老化测试24小时。

4 test aging: after all the LED is good, check the processing is not bright, and then the aging test for 24 hours.

5.封胶:把LED固定到铁皮上。

5 glue: fixed LED onto tin.

6.再测试,安装。

6 re testing, installation.