新闻中心

  • 新闻中心
您现在的位置:主页 > 新闻中心 >

新闻中心

工作习惯对济南广告大字喷绘喷头的影响

页面更新时间:2015-06-29 10:52 来源:未知 作者:admin 点击:

注意吸尘器吸管口上不能有毛刺,以免在抽吸过程中划伤喷头。 喷头最怕的是干燥只要你想办法不要让喷头干燥。用好的方法保护好喷头 是不会堵头的 。墨水的不好使用主要表现在出墨不畅、糊头(表现为找在画面上出现V字形) 。济南广告大字 http://www.kangmingda.com/ 色彩不亮发灰,褪色快等等

Note that the suction nozzle can not have a burr, so as not to scratch the nozzle in the process of suction. The most afraid of the nozzle is dry as long as you want to do not let the nozzle dry. Good method to protect the good nozzle is not blocked. Ink is not good use of the main performance in the ink is not smooth, paste the head (performance for the appearance of the V font). Ji'nan advertising character color is not bright hair gray, fade quickly, etc.

(7)、墨水黏度过高-----墨水黏度过高会造成墨水在输墨管内黏结,导致供墨量不足、喷墨量不够、颜色断层。特别在冬季,气温低,这种现象更为突出。

(7) the ink viscosity is too high, the ink viscosity is too high will cause the ink in the ink in the ink, resulting in insufficient supply of ink, ink, color, color. Especially in winter, the temperature is low, this phenomenon is more prominent.

解决方法:提高室内温度(如开空调,用烘干机、电热器等),使墨水黏度降低。或使用黏度较底的墨水。

Solution: to improve the indoor temperature (such as open air conditioning, with the dryer, electric heater, etc.), so that the viscosity of ink. Or use of a low viscosity ink.

(8)墨水黏度过低------墨水黏度过低,墨水过于稀释,喷墨速度就快,墨水喷到灯布上会反射回喷头,造成墨水郁积在喷嘴上,致喷头堵塞。长时间喷同种颜色此种现象更为突出。

(8) ink viscosity is too low, the ink viscosity is too low, ink too diluted, ink-jet speed, ink jet to light cloth will reflected back to the applicator, causing stasis ink in the nozzle, nozzle clogging. The phenomenon of long time spraying of the same color is more prominent.

解决方法:用专业棉棒粘清洗液擦洗喷头。如要彻底解决这个问题则要更换黏度高墨水。

Solution: use professional cotton swab stick cleaning fluid to scrub the shower nozzle. To solve this problem, we should change the viscosity of high ink.